The hanging device of the electromagnetic iron remover should be selected according to actual needs

The hanging device of the electromagnetic iron remover should be selected based on the actual needs of the on-site working environment. It should be purchased after determining the hanging position and environmental conditions of the electromagnetic iron remover. When the on-site environment of the electromagnetic iron remover is special and the conditions are complex, we will carry out special designs for users to meet the actual working conditions. For belt conveyors with a belt width of less than 1400mm, Permanent Magnetic Separators are recommended; for those with a belt width of over 1600mm, electromagnetic separators are recommended. When the electromagnetic iron remover is installed at the head of the belt conveyor, due to the inertial force of the material, it is in a loose state when leaving the belt, which is conducive to iron removal. If the drive of the belt conveyor head is changed to be made of non-magnetic materials, the iron removal effect will be better.

When installing an electromagnetic iron remover in the middle of a belt conveyor for iron removal, the idlers under the electromagnetic iron remover can be changed to non-magnetic flat idlers, which can further improve the iron removal effect. When the material contains a large amount of impurity iron, a self-unloading magnetic separator should be selected. When the power capacity is insufficient, permanent magnetic separators should be selected. When the dust in the on-site environment is severe, a fully enclosed structure magnetic separator should be selected. When a high rate of impurity iron removal is required, different working methods of iron removal equipment can also be used in combination. For example, permanent magnetic rollers can be used at the head of the belt conveyor, and electromagnetic iron removers can be selected in the middle of the belt conveyor.